Until then we have to work around things.įirstly I have to ask, have you considered printing the part upright ? To me that would be the most logical way as there would be zero support required. (also PS 2.4 which isn't out yet is supposed to give us more options for support to make it better). There are tricks you can do to get around that though. Unfortunately with PS the first layer below support is not the best way as those curving tracks can peel up on a lot of surfaces. With the orientation you are printing that part with the large amount of support if your first layer isn't perfect you are going to have trouble. With your print surface I dont know if the same holds true but I suspect it does. With a pei surface if things don't stick its usually down to 1 or 2 things, bed is not 100% clean of all oils and grease (finger prints being the common culprit) and the z height of that first layer. Once you can print them without gaps in the lines you know you have your first layer and level adjusted properly. There are loads of them but they are all basically a single layer print designed to cover strategic areas of your bed. Printing one of the bed level models is a good way to check. Looking at your start gcode it looks like yours doesnt as there are no mesh leveling commands there. Its why I was asking about mesh, as some other printers including some of the creality models have ABL using things like a bl touch probe or similar. With something like a Prusa it has mesh bed leveling and a way to adjust the distance on the lcd which makes this process easier. However its a fine line between close and being on. Normally you leave that alone and actually adjust your printers bed, which it sounds like you have done. The z offset is not a good way to adjust, that setting is why you will keep getting the red warning when slicing as the gcode is outside the print area. Other useful ones are volumetric flow so you can see if any part is getting close to your hotend limits. You can then see how fast slicer is instructing the printer to go in the preview. However if you look in the bottom right corner you will see a dropdown. So outer perimeters are a dark orange, normal perimeters are yellow, overhangs are blue etc. ![]() In its normal mode the slice is colour coded by feature. When you slice a file and PS goes to the preview window. ![]() What print surface does the ender v2 use ? And does it require bed levelling, have mesh levelling etc ? If you want to also add your output gcode or the original model to the zip archive you can, sometimes that’s useful depending on what the potential issue is. With the project we can slice and look at the previews. It must be zipped or the forum won’t accept the file type. You then need to zip that 3mf file up and attach it to a post here. The 3mf file contains your models, all your settings and any modifiers, variable layer heights etc. Normaly to debug these sort of issues you need to save your project using file>save project as. What does the speed preview show for the first layer ? However that doesn’t mean it’s using them. It’s why the function load config from gcode works, as there’s a copy of the print settings stored in the file. The lines at the bottom are just comments with the profiles settings. RE: Ender 3 v2 not following PrusaSlicer GCode
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |